It's pretty chilly here, but I need to do some priming, so I temporarily setup the infrared heater.

Primed the inside surface of the canopy skin.

Got my dimpling platform out and dimpled the canopy skin.

Here, where the skin overlays the canopy frame, I applied some paste wax around this one rivet hole that happens to be on the bend. Initial thinking is that I need a blob of epoxy right under the skin at this location so that when I install a rivet here, it doesn't cause a pucker. And if I'm going to be using the skin as a form for that blob of epoxy (and micro), I don't want it to stick. Hence, the wax.